[vc_row][vc_column][vc_column_text]
FIX 10-S – Ultra Fast-setting Cementitious Water Stop
Description:
FIX 10-S is an ultra fast setting, chloride free hydraulic cement for use on concrete substrates, which sets immediately when exposed to water. Note: In most cases FIX 10-S can be applied as dry powder without mixing. Where mixing is desired carry out as follows:
- Mix with clean water to obtain desired consistency.
- Setting time is dependent on the amount of mixing water used and the temperature of the water.
- Warm temperatures accelerate the set, cold temperatures retard it.
- Mix only small quantities of material at a time.
[/vc_column_text][vc_row_inner][vc_column_inner width=”1/2″][vc_column_text]
Application methods
- Dry Method: For most leaking areas, firmly press FIX 10-S powder against the active leak, and rub until the water stops. For large areas of moisture penetration, rub FIX 10-S powder into wet surface area.
- Mixed Method: When desired, mix an appropriate amount of material as described above. Place FIX 10-S firmly into the crack or hole using gloved hand or a brick jointer. Hold firmly in place until material has set, approx. 10 – 30 seconds. Strike off flush with surface.
Download FIX 10-S Technical Data Sheet
[/vc_column_text][/vc_column_inner][vc_column_inner width=”1/2″][vc_column_text]
Typical Applications:
- Plugs/stops active water leaks
- Dries out wet areas
- Seals leaky joints, cracks or formtie holes
Benefits:
- Stops water leaks in less than 30 seconds
- Easy application – no mixing needed in most cases
- Waterproof
- Durable
- No odor – no fumes
[/vc_column_text][/vc_column_inner][/vc_row_inner][/vc_column][/vc_row]